Get her sharp and choke up on that bitch
Machine tools and stuff...
- Thread starter thomas1
- Start date
Get her sharp and choke up on that bitch
T1 had a girlfriend like that ! Y/N
The mill is 110"×34"
Last one that was welded up. Every shiny spot, used to be weld...
If that's width x height, T1 dated a girl like that
What Kind of Materials Can Be Broached? | Miller Broach
The best materials to use in a broaching machine are softer, but some high-tensile steel and other hard metals can also be successfully broached.
“Stainless steel, while durable and reliable for most parts, is difficult to broach. It tends to dull the teeth, particularly harder grades of stainless steel. Use medium cuts and aim for a hook angle between 15 and 20 degrees.”
My 6.50$ angle plate. Got a pair of them for 13$ at auction. Taking this one to wi see if it helps with a setup. 24x30x72 roughly
Well the angle plate seemed to have paid for itself
Now that one setup can cut that entire box with only some minor adjustments of some screws.
That box consists of the 3 sides L R and rear broken up into 6 surfaces. That will hopefully be parallel/square within .005"
It did cost 50$ to hire the rigger to load them in the trailer. Lol
Girls dated a T1 like that.
Wuz one of you fawkers looking to buy a quick change toolpost for a lathe? I got sum sales email with some stuff listed.
No, Dorian was the first to copy the Aloris, I think. They’re in the USA. Slightly cheaper than an Aloris, I think, but significantly more expensive than a Chicom copy.