Yes HSS
Get her sharp and choke up on that bitch
Yes HSS
T1 had a girlfriend like that ! Y/NGet her sharp and choke up on that bitch
The work you do is interesting.View attachment 844View attachment 845
The mill is 110"×34"
View attachment 846
Last one that was welded up. Every shiny spot, used to be weld...
The work you do is interesting.
I picked that up from Laroo.Bet that's not the first time you've used that line unsuccessfully.
If that's width x height, T1 dated a girl like thatThe mill is 110"×34"
View attachment 1022
My 6.50$ angle plate. Got a pair of them for 13$ at auction. Taking this one to wi see if it helps with a setup. 24x30x72 roughly
View attachment 1129
Well the angle plate seemed to have paid for itself
Now that one setup can cut that entire box with only some minor adjustments of some screws.
That box consists of the 3 sides L R and rear broken up into 6 surfaces. That will hopefully be parallel/square within .005"
It did cost 50$ to hire the rigger to load them in the trailer. Lol$6.50 well spent.
View attachment 1129
Well the angle plate seemed to have paid for itself
Now that one setup can cut that entire box with only some minor adjustments of some screws.
That box consists of the 3 sides L R and rear broken up into 6 surfaces. That will hopefully be parallel/square within .005"
Girls dated a T1 like that.It did cost 50$ to hire the rigger to load them in the trailer. Lol
Is that some of China's finest work?