LOL, when did GM start making Yamaha's?Told ya that anything made by GM is a total POS
LOL, when did GM start making Yamaha's?Told ya that anything made by GM is a total POS
All i have is C4Have you tried dynamite or shooting it?
Bring it up here to Igloo just South of Tater Island and leave it for a bit , we'll get more rust on it then cut it off lolHoly mother of abuse and neglect, this rusted up POS. that hub ain't comin off. it is rusted bad and something is definitely fried in there. i got it soakin with PB Blaster. if that don't work gonna put some heat to it or you guys got a better idea?
I got pullers, they wont work if that castle nut don't come off.Get you the proper puller and then use heat if required
Bolt-Type Wheel Puller Set
Amazing deals on this Bolt-Type Wheel Puller Set at Harbor Freight. Quality tools & low prices.www.harborfreight.com
Get a 4 foot long peice of angle iron, drill two holes in it at one end and bolt it on. Put your ratchet on and jump on it.Can't get real crazy with it cause it's full time 4wd and it turns all that stuff in the pumpkin. probably break some of it to get real crazy with it.
You talkin about bolting the angle iron to the lug bolts right? that might werk if the lugs don't break. gonna try the heat and impact first. gotta go to grocery store first though.Get a 4 foot long peice of angle iron, drill two holes in it at one end and bolt it on. Put your ratchet on and jump on it.
Its almost midnight and your worried about getting hard shell ffs.You talkin about bolting the angle iron to the lug bolts right? that might werk if the lugs don't break. gonna try the heat and impact first. gotta go to grocery store first though.
Tom dated a gal like thatI’d throw some heat on it even before putting the impact on it with how rusty that looks.
Heat it cherry red and then go to the store and let it cool down.You talkin about bolting the angle iron to the lug bolts right? that might werk if the lugs don't break. gonna try the heat and impact first. gotta go to grocery store first though.
Tom dated a gal like thatHeat it cherry red and then go to the store and let it cool down.
Happy groundhogs day.Happy birthday rich
You can also cut across the threads on the nut a little with a hacksaw will release pressure of the nut against the bolt.Heat cherry red, spray lots of knock ‘er loose, impact, heat, spray, impact..cheater bar, heat, spray....
When heated the cooling effect of penetrating oil creates a vacuum, pulling the penetrant into the threads..it’s physics.
Or cut the nuts off, like poor poor Fred.
Didja take the cauter pin out ??you should take the cauter pin out !!🤔😳😉Holy mother of abuse and neglect, this rusted up POS. that hub ain't comin off. it is rusted bad and something is definitely fried in there. i got it soakin with PB Blaster. if that don't work gonna put some heat to it or you guys got a better idea?
LOL, I got three bottles in the cabinetIts almost midnight and your worried about getting hard shell ffs.
Yes the lug studs, havent broken a stud like that yet.
scared to get it that hot, there is a boot right behind it on the shaft.Heat it cherry red and then go to the store and let it cool down.
Yup, it was hard to get out too. anyway i ain't foin nothing to it til i get back from the store. i don't want to get soaked first and it's humid as all get out.Didja take the cauter pin out ??you should take the cauter pin out !!🤔😳😉