LOL, when did GM start making Yamaha's?
Not So Pros v3.0
- Thread starter thomas1
- Start date
Air hammer with the proper bit will help move a lot of stuff. Put tension on it , spray it with blaster, a lot of times the vibration will break the rust free
Can't get real crazy with it cause it's full time 4wd and it turns all that stuff in the pumpkin. probably break some of it to get real crazy with it.
Get you the proper puller and then use heat if required
www.harborfreight.com
Bolt-Type Wheel Puller Set
Amazing deals on this Bolt-Type Wheel Puller Set at Harbor Freight. Quality tools & low prices.
www.harborfreight.com
Bring it up here to Igloo just South of Tater Island and leave it for a bit , we'll get more rust on it then cut it off lolHoly mother of abuse and neglect, this rusted up POS. that hub ain't comin off. it is rusted bad and something is definitely fried in there. i got it soakin with PB Blaster. if that don't work gonna put some heat to it or you guys got a better idea?
That looks like a 4yr old part up here .
Thot of you Yahoos today on the way home , the car in front of me's plate was FJB xxx lol
I got pullers, they wont work if that castle nut don't come off.Get you the proper puller and then use heat if required
Bolt-Type Wheel Puller Set
Amazing deals on this Bolt-Type Wheel Puller Set at Harbor Freight. Quality tools & low prices.
Plan-b
Canada is a 3rd world shit hole. Change my mind
Get a 4 foot long peice of angle iron, drill two holes in it at one end and bolt it on. Put your ratchet on and jump on it.
You talkin about bolting the angle iron to the lug bolts right? that might werk if the lugs don't break. gonna try the heat and impact first. gotta go to grocery store first though.
Plan-b
Canada is a 3rd world shit hole. Change my mind
Its almost midnight and your worried about getting hard shell ffs.
Yes the lug studs, havent broken a stud like that yet.
Heat it cherry red and then go to the store and let it cool down.
Heat cherry red, spray lots of knock ‘er loose, impact, heat, spray, impact..cheater bar, heat, spray....
When heated the cooling effect of penetrating oil creates a vacuum, pulling the penetrant into the threads..it’s physics.
Or cut the nuts off, like poor poor Fred.
When heated the cooling effect of penetrating oil creates a vacuum, pulling the penetrant into the threads..it’s physics.
Or cut the nuts off, like poor poor Fred.
You can also cut across the threads on the nut a little with a hacksaw will release pressure of the nut against the bolt.
Didja take the cauter pin out ??you should take the cauter pin out !!🤔😳😉Holy mother of abuse and neglect, this rusted up POS. that hub ain't comin off. it is rusted bad and something is definitely fried in there. i got it soakin with PB Blaster. if that don't work gonna put some heat to it or you guys got a better idea?
LOL, I got three bottles in the cabinet
scared to get it that hot, there is a boot right behind it on the shaft.
Yup, it was hard to get out too. anyway i ain't foin nothing to it til i get back from the store. i don't want to get soaked first and it's humid as all get out.