Prolly no spark. I think those are kinda known for bad ignition.. how many annular cutters were harmed drilling that bar I wonder.@roberte did you leave something up here?
Jonsereds 80 Chainsaw with Alaskan Mill - farm & garden - by owner -...
Jonsereds 80 Chainsaw with Alaskan Mill setup. This is an 80cc, just under 5HP Chain Saw. It is not currently starting but has very good compression. It is from my Brothers Estate. Has a unique heat...portland.craigslist.org
Usually lots out at the curb on garbage day with very little wrong with themI have no idea. Maybe look for a cheap used mower for a donor engin?
No@roberte did you leave something up here?
Jonsereds 80 Chainsaw with Alaskan Mill - farm & garden - by owner -...
Jonsereds 80 Chainsaw with Alaskan Mill setup. This is an 80cc, just under 5HP Chain Saw. It is not currently starting but has very good compression. It is from my Brothers Estate. Has a unique heat...portland.craigslist.org
$400 is awfully ambitious@roberte did you leave something up here?
Jonsereds 80 Chainsaw with Alaskan Mill - farm & garden - by owner -...
Jonsereds 80 Chainsaw with Alaskan Mill setup. This is an 80cc, just under 5HP Chain Saw. It is not currently starting but has very good compression. It is from my Brothers Estate. Has a unique heat...portland.craigslist.org
Buffet leftovers?Usually lots out at the curb on garbage day with very little wrong with them
I wonder why there are no vertical shaft motors at Harbor Freight now?
@Dieselfitter What is a good replacement engine for a log splitter? Vertical shaft 6hp.
your pump wont know or care what orientation it is in.I wonder why there are no vertical shaft motors at Harbor Freight now?
@Dieselfitter What is a good replacement engine for a log splitter? Vertical shaft 6hp.
sob looks crispy
Just turn it on it's side?your pump wont know or care what orientation it is in.
It does on firdoes at charred bark dull the hell outta chain?
What are these leftovers you speak of?Buffet leftovers?
I wonder how many choice words were used in the drilling of said bar.Prolly no spark. I think those are kinda known for bad ignition.. how many annular cutters were harmed drilling that bar I wonder.
yeah you can. it is best if the suction is lower than the bottom of the tank, or at least the fluid level. but i have seen factory rigs higher than Rob.Just turn it on it's side?
He dead?10s of people were upset with his passing
Is it a short shaft? Just drive around on garbage day in the fancy neighborhoods and look for a pressure washer. I have one, i can send it freight colect... LolI wonder why there are no vertical shaft motors at Harbor Freight now?
@Dieselfitter What is a good replacement engine for a log splitter? Vertical shaft 6hp.