Mornin pals..............................................................................42°/61°
Thansk for pointing that out.Tomorrow is flyday Brad
Good afternoon ! Got my biopsy results . Came back clean ! I was expecting the worse ,and was prepared for it . Couldn’t be happier ,or more relieve . The best thing is the look of complete relief on Jan’s face .
Congrats fellas.Good news John, glad to hear it.every little gain i make around here seems to effect the wimmen folks more too .things that i hardly notice have them losing thier mind.
Its a lot fun putting them in place, at least it was on 009s and 011s, but those had a cage on the piston pin. They make a tool that holds them on the crank (of course Stihl made a tool for it), it didn't seem any easier than some red and tacky or some green Rotella goop. My usual grayish graphite motor putting together stuff was either absent or not up to task.Good Morning ! 42/50 semi-sunny ,reins later . Gots some chains to do . I found an interesting feature on the 015L . All the bearings are non caged needle/roller type . And in 3 different sizes too . And they were so happy to gain their freedom from the crankcase . Cute little merfers ...
Mornin 36/72 sunz
No plans
Have a good one
I use assembly grease . Works fairly well . You gotta remember to try to keep it off your fingers as much as possible . If the bearing has a choice between going and staying where it’s supposed to go ,or your finger , it’ll take your finger every time . Unless,of course , it can jump straight to the floor ,never to be seen again ...Its a lot fun putting them in place, at least it was on 009s and 011s, but those had a cage on the piston pin. They make a tool that holds them on the crank (of course Stihl made a tool for it), it didn't seem any easier than some red and tacky or some green Rotella goop. My usual grayish graphite motor putting together stuff was either absent or not up to task.
As t one says, the stickier the better.
I use assembly grease . Works fairly well . You gotta remember to try to keep it off your fingers as much as possible . If the bearing has a choice between going and staying where it’s supposed to go ,or your finger , it’ll take your finger every time . Unless,of course , it can jump straight to the floor ,never to be seen again ...