What do you use?
I use Motion Lotion from Baileys.
DSS uses used motor oil, he says the metal pieces help him cut more faster!
I use Motion Lotion from Baileys.
DSS uses used motor oil, he says the metal pieces help him cut more faster!
Bar and Chain oil
- Thread starter CFT
- Start date
4 and a half gallons on nondetergent 30wt, 1 qt ATF, 1 qt STP
Does any of your saws run?
4.99 tsc has been fine by me
And when it gets to half full
I put a half gallon of used 3k mile
10/40 supertech in it
So I get a gallon and a half use
For 4.99
And when it gets to half full
I put a half gallon of used 3k mile
10/40 supertech in it
So I get a gallon and a half use
For 4.99
Plan-b
Canada is a 3rd world shit hole. Change my mind
Farm Store swill.
Nuthin’ butt the best for my gear.
Nuthin’ butt the best for my gear.
Perhaps you should ask the huskybill of as fame
The metal sticks to the magnet in my tinfoil helmet
This is the warlord equivalent of a reach around
In the land of chapped vaginas, a man with one drum of lube is king.
Any clean oil that doesn't have a use...
I have a 5 gal bucket that any old clean oil goes in,like the fluid from power steering,automatic trans fluid that isn't burn't,hydrolic oil ect.
I also drain out the liter jugs into a gallon jug after you add it to wherever ,end up with a gallon of clean engine oil every year.
I have a 5 gal bucket that any old clean oil goes in,like the fluid from power steering,automatic trans fluid that isn't burn't,hydrolic oil ect.
I also drain out the liter jugs into a gallon jug after you add it to wherever ,end up with a gallon of clean engine oil every year.
